Active Vision SX-420 - Page 36

Active Vision SX-420 User Guide
36
If the network connection does not allow additional IP addresses, than an IP sharing device will
be needed. In this case, forwarding may be needed to allow for a network connection. For more
information on port forwarding, see the documentation for your IP sharing device or your network
administrator.
ADSL
To use the ADSL option when connecting the DVR to a network, the following information is
required. If you do not have this information, see your network administrator.
Table 3.7.3. ADSL
Item Description
ID
The user ID for ADSL connection
PASSWORD
The password for ADSL connection
User’s ADSL connection must have an RJ45 output to connect to the DVR.
When sharing the connection with other devices, an IP sharing device should be used. In this
case, select LAN as the NETWORK type. User will also need to configure the IP sharing device
for port forwarding to allow for a network connection. For more information on port forwarding,
see the documentation for your IP sharing device, or contact your network administrator.