EasyManua.ls Logo

ActronAir CP05 - Troubleshooting Guide

ActronAir CP05
36 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
32
Operation Manual - (CP05 / CP10) Commercial Control Interface
Doc. No. 0525-031 Ver. 3 190308
CONDITION CAUSES OR CHECKPOINTS
The system
does not start
• Check that 5 minutes has passed from Turn-On time, as the system has
inbuilt timers.
• Check that setpoint temperature settings are correct.
• Check that the setpoint temperature is set low enough for cooling or
high enough for heating.
Air does not ow
(Indoor Unit)
During heating operation, air does not ow out for approximately 15
seconds after start up, this prevents cold draft.
Cooling/Heating is
not sufcient
The cooling/heating function may not work effectively when the indoor
"return air lter" is clogged with dust and dirt.
• Make sure the air inlet and air outlet on the outdoor unit are not blocked.
• The outside temperature is above or below the design conditions.
Steam is coming
out from the
outdoor unit
• It is caused by the defrosting of the outdoor unit in heating operation
during cold ambient conditions.
Water from the
outdoor unit
• This is normal during heating operation, which is due to water forming
on the heat exchanger.
Occurring of noises
• When heating or cooling is started or stopped, a swishing or gurgling
noise may be heared, This noise is generated by the refrigerant owing
between the outdoor and the indoor units.
• A swooshing noise may be heared from the outdoor unit during
operation. This noise is generated when the refrigerant changes
direction in the defrost operation.
• On start up, the outdoor unit may be louder than normal for a few
seconds while the compressor reaches the designated speed and
operating pressure.
• During defrost operation, the compressor may generate more noise than
normal.
Setpoint
Temperature cannot
be adjusted
• The Control Interface has inbuilt upper and lower limit setting. Setpoint
temperature can only be adjusted within these limits.
7-Day Timeclock is
not turning the air
conditioner On and
Off
Check that the timeclock is activated (see pages. 23-24).
NOTE: Before contacting your installer for further assistance, please have your airconditioner's
Model No. and Serial No, with you. (See page 35).
TROUBLESHOOTING GUIDE

Other manuals for ActronAir CP05

Related product manuals