ActronAir CP05 - System Configurations

35
ActronAir
®
is constantly seeking ways to improve the design of it’s products, therefore specications are subject to change without notice. Please check prior to purchase.
Copyright © 2016 Actron Engineering Pty. Ltd.
UNIT INFORMATION
Model Number : Serial Number :
The air conditioner model and serial number is situated on the side panel
of the unit’s bottom left corner, near the compressor compartment.
Date Installed :
SYSTEM CONFIGURATIONS (To access this menu, please enter the Service password: 7378).
G. Service e. Communicate cong.
G. Service f. Service settings
a. Working hour set
Enable BMS to turn the unit On/Off Indoor Filter hours
On loss of communication turn off / turn on / use timeclock Indoor Fan hours
Enable Din4 to turn the unit On/Off
Compressor hours
Reset ID Fan
G. Service f. Service settings b. Probe adjustment
Reset Comp 1
Reset Comp s
(Return Air Temperature) Room Temp cal :
o
C Reset Comp 3
G. Service Service f. Service settings
c. Thermoregulation
Multi Input 1
1 Room Temperature setpoint
o
C
2. Dead band
o
C
Controlling Probe Type
3. Cool Proportion band
o
C
4. Heat Proportion band
o
C Supply Air Temp NTC
5. Integral Time seconds Phase Fail Relay
6. Room temp. probe weight value 0-10VDC In Fan Spd 0-10VDC
7. Supply Fan Min. Speed % 0-10VDC Stage Cont 0-10VDC
8. Supply Fan Med. Speed % Night Mode Enable
9. Supply Fan Max. Speed %
Economy Enable
10. Supply Fan Min. Temp.
o
C
11. Supply Fan Max. Temp.
o
C
Multi Input 2
12. Supply Fan Continuous
13. Cycle on de-ice Controlling Probe Type
14. One Speed Fan
15. Fan Speed Supply Air Temp NTC
16. Supply Fan Run-on seconds Phase Fail Relay
17. Heat Start Delay seconds 0-10VDC In Fan Spd 0-10VDC
18.
* Temp. Diff to Enable Cycle
o
C 0-10VDC Stage Cont 0-10VDC
19.
* Economy Offset Co-efcient
Night Mode Enable
20.
* Economy Proportion band
o
C
Economy Enable
21.
* Min. Outside temp.
o
C
22.
* Min. Outside position
%
Unit Control Mode
23. Setpoint Limit Min. by user
o
C
24. Setpoint Limit Max. by user
o
C Internal Sensors
25. User Setpoint Remote Terminal
26. User Mode Set Remote Demand
27. Return air temp. probe weight value seconds External Input
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Low Med High
Lock Unlock
Lock Unlock
*
These parameters are only available when economy cycle has been tted and enabled.
On Off
On Off
On Off
On Off
On Off
On Off