100S Reference Manual
30
TROUBLESHOOTING
Improper procedure Press the ENTER key after
each value is entered into a
Setup screen. If you press
another key instead, the
new value will not be
saved. Refer to pgs. 5 - 11
for proper procedures.
Setup does
not save
values
Numbers
don’t
appear/are
faded on the
display
LED failure
Turn the system “off” and
then “on” again, using the
switch on the back of the
readout. If this does not
correct the problem,
contact your
100S distrib-
utor for repair/replacement
procedures.
Symptom
Recommended
Corrective Action
Probable Cause
To Next Page
Loading...