Adafruit Feather HUZZAH ESP8266 - Using Micropython

Toggle the LED component's switch to turn the LED on and off.
Note - the Feather Huzzah ESP8266's LED is reverse wired, so setting the pin
LOW will turn the LED on. Therefore, toggling the switch low off will turn the LED
on.
Ready to learn more about WipperSnapper?
We have more WipperSnapper guides on the Adafruit Learning System >>>(https://
adafru.it/Yyd)
Using MicroPython
Using MicroPython(https://adafru.it/DH1)
•
©Adafruit Industries Page 48 of 53