Adaptec RAID Controller - Installing on a Vmware Guest os; Starting the Command Line Utility

esxcli software vib install --maintenance-mode --no-sig-check -v
/tmp/vmware-esx-provider-arcsmis.vib
When the package is installed, you receive the message "Reboot Required: false."
11. Reboot the system.
12. Continue the installation with Installing on a VMware Guest OS on page 16.
Installing on a VMware Guest OS
Note: You must complete the steps in Installing on VMware ESX 4.1 on page 14 or
Installing on VMware ESXi 5.x on page 15 before continuing.
To install ARCCONF on a VMware guest operating system:
1. Insert the Adaptec Installation DVD.
2. Go to the ASM-MANAGER-GOS directory for the remote operating system you want to install.
3. Type one of the following commands, depending on the operating system:
DescriptionOptions
./StorMan-9.00-19098.esx86_64.binLinux
setup_asm_esx_x64.exeWindows
Starting the Command Line Utility
1. To start ARCCONF, enter one of the following commands:
DescriptionOptions
<install_dir>\arcconf.exeWindows
/usr/<install_dir>/arcconfLinux
/usr/StorMan/arcconfSolaris
/<install_dir>/arcconfFreeBSD
/usr/StorMan/arcconfVMware
where Install_dir is the directory where the utility is installed.
2. To see a list of available commands, type ARCCONF at the prompt.
16Proprietary and Condential to PMC-Sierra, Inc.
Document No.: CDP-00284-01-A Rev. A, Issue:
Adaptec RAID Controller Command Line Utility User's Guide