Adaptec RAID Controller - Arcconf Failover; Arcconf Getconfig

arcconf failover
Description
Turns automatic failover on and off.
Syntax
ARCCONF FAILOVER <Controller#> <on|off>
Parameters
Controller#
The controller number.
On
Turns the controller failover mode on.
Off
Turns the controller failover mode off.
Examples
ARCCONF FAILOVER 1 ON
arcconf getcong
Description
Lists information about controllers, logical drives, physical drives, and ash backup systems. This
information includes (but is not limited to) the following:
• Controller type
• BIOS, boot block, device driver, and rmware versions
• Logical drive status, RAID level and size
• maxCache status, fetch and ush rate policy, read/write balance, SSD information
• Device type, device ID, presence of PFA
• Physical device state
• Enclosure information: fan, power supply, and temperature status
• Flash backup information (for AFM-700 ash backup module): status, charge level, temperature
readings, max voltage, current, estimated life, errors, and serial number
Syntax
ARCCONF GETCONFIG <Controller#> [AD|LD [LD#]|PD|MC|AL]
Parameters
Controller#
Controller number
23Proprietary and Condential to PMC-Sierra, Inc.
Document No.: CDP-00284-01-A Rev. A, Issue:
Adaptec RAID Controller Command Line Utility User's Guide