Adaptec RAID Controller - Arcconf Playconfig

Examples
ARCCONF PHYERRORLOG 1 DEVICE 0 0
ARCCONF PHYERRORLOG 1 EXPANDER 1 ALL
arcconf playcong
Description
Note: This command is supported on Windows systems only.
Congures a controller using a XML server template le produced by the SAVECONFIG command (see
arcconf savecong on page 33). Use this command to deploy the same controller conguration on
multiple servers in your storage space.
Note:
1. The XML server template le (default, savecong.xml) is editable. For example,
you may need to change the disk drive capacity, logical drive size, or RAID level.
2. Drives from the same vendor with slightly different capacities (147GB vs 150GB,
for instance) are considered interchangeable. If the interchange results in a change
in logical drive capacity, the drive is scaled, as needed. For example, if the new
drives have 4% more capacity due to vendor or model changes, then all logical
drives are increased in size by 4%.
3. Be sure to check the log le to verify that the controller was congured successfully.
The exit codes, shown below, indicate the success or failure of the operation and
if the system needs to be rebooted.
MeaningValueCode
Conguration succeeded, no reboot is
required.
0SUCCESS
An error occurred and the conguration
could not be completed.
1FAILURE_GENERAL
Conguration succeeded, but a reboot is
required.
2SUCCESS_REBOOT
Syntax
ARCCONF PLAYCONFIG <Input XML File> [LogFile] [FORCE ALL|LOGICALSIZE]
Parameters
Input XML File
The pathname of the server template le. The default server template le is available at
C:\PMCS\Logs\savecong.xml.
LogFile
Sets the pathname of the error log le. By default, the error log is available at
C:\PMCS\Logs\playcong.log.
FORCE
Forces deployment of the server even if the controller does not support all features, or the drive capacity
does not match the conguration in the input XML le. Use FORCE ALL to force deployment of all
features; use FORCE LOGICALSIZE to force deployment of just the logical drives.
31Proprietary and Condential to PMC-Sierra, Inc.
Document No.: CDP-00284-01-A Rev. A, Issue:
Adaptec RAID Controller Command Line Utility User's Guide