Adaptec RAID Controller - Arcconf Saveconfig

Note:
1. This function is only supported in Windows and Linux.
2. Be sure to copy the *.UFI update les from the DVD and not from the
BIOS/Firmware update diskettes.
Syntax
ARCCONF ROMUPDATE <Controller#> <BaseName> [Newversion <build#> [Force]]
[noprompt]
Parameters
Controller#
The controller number
BaseName
The name of the ROM image basename or the fully qualied name if you have a set of controller ROM
images.
Note: All UFI les must be in the same directory prior to invoking ARCCONF. If you
are copying UFI les from oppy images, be sure to check all images.
Newversion <build#>
Species the version of the rmware build.
Force
An optional parameter used to force a down-level rmware update.
Noprompt
An optional parameter that suppresses the conrmation prompt.
Examples
ARCCONF ROMUPDATE 1 AC2200
ARCCONF ROMUPDATE 1 AC220001.UFI
ARCCONF ROMUPDATE 1 AS483C newversion 12345 force noprompt
arcconf savecong
Description
Note: This command is supported on Windows systems only.
Saves the controller conguration to a XML server template le, including the controller type, operational
settings, physical drive size, logical drive size, RAID level, and more. Use this le with the PLAYCONFIG
command to deploy the same controller conguration to other servers in your storage space; see arcconf
playcong on page 31 for more information.
Note: Be sure to check the log le to verify that the conguration XML le was created
successfully. The exit codes, shown below, indicate the success or failure of the
operation.
MeaningValueCode
Conguration XML generated successfully.0SUCCESS
An error occurred and the conguration XML
could not be generated.
1FAILURE_GENERAL
33Proprietary and Condential to PMC-Sierra, Inc.
Document No.: CDP-00284-01-A Rev. A, Issue:
Adaptec RAID Controller Command Line Utility User's Guide