DOMINO 24 & 48 USER MANUAL
www.adblighting.com
User Manual - page 26
Issue 1.2
7.7.2 FADE TIMES
To read and/or edit the IN or OUT fade times in a theatrical memory, edit the theatrical
memory as described above then use the function button to select each time
IN TIME.
Repeatedly press [function] until the “in” indicator lights. The display prompts you then
shows the IN fade time. The fade time may be edited by rotating the EDIT wheel. When a
time is set lower than 0 seconds, it is controlled by the rotating speed fader.
OUT TIME.
Repeatedly press [function] until the “out” indicator lights. The display prompts you then
shows the OUT fade time. The fade time may be edited by rotating the EDIT wheel. When a
time is set lower than 0 seconds, it is controlled by the rotating speed fader.
7.8 COPYING FROM/TO STAGE OR PRESET
Not implemented at writing of manual
7.9 CLEARING STAGE OR PRESET
To remove (clear) the theatrical list from the cross-fade, press[remove] [Stage] or [Preset]
the display says “EMPTY X-FADE? Press [Yes]
To Next Page
Loading...
Need help?
General
