DOMINO 24 & 48 USER MANUAL
www.adblighting.com
User Manual - page 61
Issue 1.2
18.10 VIDEO
18.10.1 VIDEO MONITOR
If your DOMINO is fitted with the optional VIDEO output connector plug a SVGA monitor into
the VIDEO connector to access the following displays
Typical video screen.
The video screen is divided into the main display (the white area on this simulation) and the
selectable areas (the dark areas on the left).
18.10.2 MAIN DISPLAY
The main part of the screen shows the fixture intensities (cyan bargraphs) at the top, a
message area in the middle and the status of the submasters and masters at the bottom.
The bargraphs are laid out in a similar fashion to the DOMINO faders. Their intensity levels
are shown in tens on the side axis of the display and in units inside each individual bar. The
intensity levels are shown prior to the patch.
18.10.3 SELECTABLE AREAS
The left side of the screen is selected by the operator and shows either:
• 1 of 3 selectable video pages (not shown above, see below) or
If none of the 3 pages are selected it further divides the left side into 4 areas and allows you
to select 4 “pin”
18.10.4 VIDEO 1 TO 3
To turn on one of the 3 video pages on the left of the screen;
HOLD [function], tap [f/a] (video 1 to 4).
• Video 1 is “Channel View”
• Video 2 is “DMX Output”
• Video 3 is “X Fade and Cue List master”
To turn off the current video page on the left of the screen;
HOLD [function], tap [f/a] (video 1 to 3).
channel output
levels.
“Pinned”
video 1
Masters - Cue list
X-fade – A / B fader
“Pinned”
video 2
To Next Page
Loading...
Need help?
General
