DOMINO 24 & 48 USER MANUAL
www.adblighting.com
User Manual - page 43
Issue 1.2
13. CUE LIST
13.1 OVERVIEW
A CUE LIST is a recorded list of steps that are to be replayed in order. Each step consists of
either a submaster memory, a chaser or a snapshot of the output (which is taken when that
step is added). Stepping from one step to the next is a Dipless Crossfade and is usually
executed manually but can be automatic. Each Cue list and each step can be named.
Up to 500 steps may be recorded in each cue list and up to 108 (216) separate cue lists may
be recorded into submaster memory. If all the lighting cues in a "show" have been recorded
into a "cue list", then the entire show may be performed on the cue list master by simply
pressing the forward " > " button for each lighting cue.
Cue lists are recorded by page/cue list number. Page numbers are selected with the [Bank
B] button and cue list numbers are selected with the [f/a] buttons. Cue lists may be randomly
recorded into any page, f/a number, however memories, chasers and cue lists use the same
submaster locations. A cue list recorded in a previously used submaster will overwrite the
previous contents.
Cue lists may only be replayed on the Cue list Master, which provides comprehensive
facilities to control the replay of the Cue list. Crossfade times for each step are recorded into
cue list or can be under control of the rotating speed fader. Each step can be given a “link“
time causing it to automatically step after an elapsed link time.
A cue list may be edited. The contents of any step may be changed; the fade and link times
varied and steps may be inserted or deleted. A cue list may be copied onto another page/ f/a
number or onto or from the Grab master.
13.2 RECORDING A CUE LIST
To record a cue list, press;[record cue list],[ Bank B] (optional),[f/a] (cue list number) (any
f/a). Adding steps:
• To select a submaster memory as a step press; [Bank B] (optional),[f/a] (submaster
memory).
• To select a chaser as a step press;[ Bank B] (optional),[f/a] (chaser).
• To record a snapshot (of the current output) as a step press; [record submaster
memory]. A blackout can be recorded as a step.
• To add a range of submasters (memories and or chasers) select the [Bank B] (optional)
then HOLD [f/a] (first submaster in range), and tap [f/a] (last submaster in range). Any
submaster memory in the selected range that is empty or contains a cue list will be
ignored.
Continue to add steps. You may mix snapshots, chasers or memories in any order.
When all steps have been added, complete the cue list by pressing; [record cue list].
13.2.1 REMOVING STEPS
Whilst recording the cue list (above), the last step may be deleted by pressing; [remove].
13.2.2 FADE AND LINK TIMES
As each step is added (above) you may set the fade IN, OUT and LINK times (automatically
links to next step after link time expires) for that step.
After each step has been added, repeatedly press [function] to cycle through the fade IN
time, fade OUT time and LINK time. When any of the time settings are indicated, rotate the
EDIT wheel to set the desired time. The maximum time is more than 16 minutes and the
minimum time is 0 seconds. When a time is set lower than 0 seconds, it reverts to rotating
speed fader.
To Next Page
Loading...
Need help?
General
