DOMINO 24 & 48 USER MANUAL
www.adblighting.com
User Manual - page 63
Issue 1.2
The display will show the battery voltage.
It should be between approximately 5.8 and 6.4 volts. Press [ok].
The display will show the state of the battery as either, charging or charged.
To exit, press [ok].
18.11.6 SYSTEM ERROR INFORMATION
Enter diagnostics mode (above) then press channel B [f/a] (10).
The window pops up on the video screen show showing any system error information. In the
event of any problems, this information can be conveyed to ADB to assist in fixing problems.
To exit, press [ok].
18.11.7 MEMORY TEST
Enter diagnostics mode (above) then press channel A [f/a] (12).
The display will show the percentage of memory used.
Press [ok].
The display will show the percentage of heap used. (Internal ADB information).
Press [ok].
The display will show the memory capacity fitted to the DOMINO.
To exit, press [ok].
To exit diagnostics mode press [no].
To Next Page
Loading...
Need help?
General
