IRIS-4 Technical Reference Manual.docx 12/01/2023 page 13
4 Basic setup
4.1 Before you begin
ARC
Make sure that the Alarm Receiving Center (ARC) to which the terminal will send alarm signals has the
appropriate IRIS Secure Apps (ISA) receiving system. The following information should be obtained from the
ARC.
Terminal account no:
ARC IP address:
Ethernet connection details
If the installation uses Ethernet, the customer’s Ethernet network (LAN) must be connected to the terminal.
Obtain the following information from the customer.
Will the terminal be required to use either:
Fixed IP address or Dynamic Host Configuration Protocol (DHCP)
Note: If using Fixed IP Address, then the following additional information will be required
.
IP address:
Gateway address:
Subnet mask:
Cellular SIM card and Access Point Name
If the installation uses cellular then a SIM card will be required. The terminal will also need to be given a
cellular Access point name (APN) and other possible configurations. Obtain the information from your SIM
card provider.
APN:
Username (USR):
Password (PWD):
SIM pin code:
To Next Page
Loading...