Need help?Do you have a question about the AddSecure IRIS-4 440 and is the answer not in the manual?
Steps to set or change the installer's password for security.
How to access the terminal configuration wizard.
Overview of initial settings within the configuration wizard.
Details the setup and testing of communication paths.
Verifies the terminal's Ethernet connection status.
Configuration and verification of the terminal's IP address.
Configuration of Wi-Fi network name and password.
Verifies the terminal's Wi-Fi connection.
Checks the terminal's registration status on the cellular network.
Displays and assesses the cellular signal strength.
Configures pin inputs for use as alarms with various formats.
Selects communication paths for polling and alarms.
Sets the terminal's account name/number allocated by the ARC.
Configures the IP address of the Alarm Receiving Center.
Sets up IP address, subnet mask, and gateway for Ethernet 1.
Configures Eth 2 for bridging between Eth2 and cellular interface.
Sets the Wi-Fi network name (SSID).
Sets the Wi-Fi access password.
General| Brand | AddSecure |
|---|---|
| Model | IRIS-4 440 |
| Category | Touch terminals |
| Language | English |
To Next Page
