DMX OPERATOR-I
PAGE 6 OF 7
III. Be sure that the Auto trigger & MUSIC trigger LEDs are both off.
IV. Select the bank that stores the scenes you wish to run by use BANK ▲ (or ▼) button.
V. Press the SCENE button to run the scene you selected.
2.AUTO RUN MODE
I. In this mode, you are to run a bank of programmed scenes in a sequential loop.
II. Press Auto/Del once to activate the AUTO RUN mode.
III. Use the BANK ▲ (or ▼) button to select a bank of scenes to run.
IV. Use SPEED and FADE TIME sliders to set running mode of the scenes. The FADE TIME setting should
never be slower than the SPEED setting. Or else the whole changing course between scenes will never
perform completely.
V. You can change bank on the fly by pressing the BANK ▲ (or ▼) button.
3.MUSIC RUN MODE
I. Press the Music/Bank-Copy button till the corresponding LED indicator illuminates.
II. Use the BANK ▲ (or ▼) button to select a bank to run, or you may choose control via MIDI signal.
III. Press the MUSIC/BANK COPY button till the corresponding LED indicator goes out will exit this mode.
RUN CHASE
1. MANUAL RUN MODE
I. This function will allow you to manually step through a selected chase.
II. MANUAL RUN mode will override the programmed scene setting. If the fade time is set to off, the chase
will run to fade time setting as per the programmed setting.
III. Press and hold the PROGRAM button for 3 seconds to enter PROGRAM mode.
IV. Start a chase by selecting the corresponding CHASE button as you want.
V. Press TAP SYNC/DISPLAY button till the LCD shows the current chase# + step#.
VI. Use BANK ▲ (or ▼) button to scroll through the chase. One press, one step forward (for button ▼) or
one step backward (fro button ▲) in the chase.
VII. Press and hold the PROGRAM button for 3 seconds again to exit PROGRAM mode.
2.AUTO RUN MODE
I. Press AUTO/DEL once to activate the AUTO RUN mode. The LED beside the button will flash.
II. Choose your desired chase (or chases) by pressing one (or several) CHASE button(s).
III. Use SPEED and FADE TIME sliders to make the desired setting.
IV. You may choose to set the speed by two times tapping on the TAP SYNC/ DISPLAY button. The interval
between the two tappings is setting of speed. If tap more than two times, then the interval between the
last two tappings is setting of speed. The tap setting will override the slider setting.
3.MUSIC RUN MODE
I. Press the MUSIC/BANK COPY button till the Music trigger LED flashes.
II. Press CHASE button to select a chase to run.
NOTE: When you exit a chase by pressing the CHASE button till the corresponding LED extinguishes, the
controller will automatically adopt the scenes stored in the last bank accessed. To stop the running, using
the BLACKOUT button (till the Blackout LED blinks), or pressing MUSIC/BANK-COPY button (till the Music
trigger LED extinguishes), or pressing AUTO/DEL button (till the Auto trigger LED extinguishes)
MIDI OPERATION
To Next Page
Loading...
