ADJ FOC635 - Page 28

ADJ Products, LLC - www.adj.com - Focus Spot 6Z User Manual Page 28
Focus Spot 6Z System Menu
DMX SETTINGS
- SET ADDRESS - In this submenu you can nd and set your desired DMX address.
- DMX CHANNEL MODE - In this submenu you can nd and set your desired DMX channel mode.
- NO DMX STATUS - This submenu setting is used as a precaution mode in case the DMX signal is
lost or interrupted. The operating mode chosen in this submenu is the running mode the xture
will go into when the DMX signal is lost. Listed below are the 3 modes.
• Hold Last - This setting will have the xture stay in the last DMX setup.
• Blackout - This setting will have the xture automatically go into stand by mode.
• Manual - This setting will go into the current manual control set up. See MANUAL CONTROL.
PERSONALITY
- PRIMARY-SECONDARY MODE - In these submenus, you are able to congure the xture to
function as a primary or secondary unit.
- STATUS SETTINGS - In this submenu you are able to access and adjust/change: Pan Degree,
Pan Invert, Tilt Invert, P./T. Feedback, P./T. Speed, and Hibernation.
- FIXTURE ID - In this submenu you are able to assign the universe, IP address, and mask address
for this xture.
- PROTOCOL SET - In this submenu you are able to select whether the xture will adhere to the
ArtNet or sACN protocol.
- NET SWITCH - In this submenu you are able to enable or disable the Network ports.
- FAN SETTINGS - In this submenu you are able to select your desired fan speed setting.
- DIM MODES - In this submenu you are able to select your desired dimmer mode and adjust the
dimming speed time.
- LED REFRESH RATE - In this submenu you are able to select your desired LED refresh rate.
- GAMMA - In this submenu you are able to adjust the gamma correction factor.
- RESET MOTORS - In this submenu you are able to reset selected motors.
- DISPLAY - In this submenu you you are able to adjust the display intensity, invert the display, set the
idle time before the screen auto-locks, and activate/deactivate the display lock.
- SERVICE - In this submenu you are able to access and adjust/change: the calibration (eect
adjust), activate the service port, update software, and restore the factory settings.