ADJ Products, LLC - www.adj.com - Focus Spot 6Z User Manual Page 30
Focus Spot 6Z Primary-Secondary Set Up
Primary-Secondary Configuration:
This function will allows you to link units together to run in a Primary-Secondary set-up, in which one
unit will act as the controlling unit and the others will react to the controlling unit’s built-in programs.
Any unit can be configured to act as a Primary or as a Secondary, but only one unit in a given sys-
tem can be programmed to act as the Primary.
Primary-Secondary Connections and Settings:
1. Daisy chain your units via the XLR connector on the rear of the unit. Use standard XLR data
cables to link your units together. Remember that the Male XLR connector is the input and the
Female XLR connector is the ouput. The first unit in the chain (master) will use the female XLR
connector only. The last unit in the chain will use the male XLR connector only.
2. Primary Unit:
Use the display screen and control panel to navigate to Personality > Primary. Select this sub-menu
using the ENTER button, and use the arrows to toggle between ON and OFF. Press ENTER to conrm
your selection.
3. Secondary Unit(s):
Use the display screen and control panel to navigate to Personality > Secondary. Select this sub-menu
using the ENTER button, and use the arrows to toggle between ON and OFF. Press ENTER to conrm
your selection. Repeat this step for all units that will operate in the slave mode setting.
4. The secondary units will now follow the behavior of the primary unit.
To Next Page
Loading...
