CHAPTER 3: Documents Basic Page Layout 28
Snapping to guides and grids
All snap settings for a document’s grids and guides are in the properties of the guidePreferences and
gridPreferences objects. The following script fragment shows how to set guide and grid snap
properties. (For the complete script, see GuideGridPreferences.)
var myDocument = app.activeDocument;
with(myDocument.guidePreferences){
guidesInBack = true;
guidesLocked = false;
guidesShown = true;
guidesSnapTo = true;
}
with(myDocument.gridPreferences){
documentGridShown = false;
documentGridSnapTo = true;
//Objects "snap" to the baseline grid when
//guidePreferences.guideSnapTo is set to true.
baselineGridShown = true;
}
Changing measurement units and ruler
Thus far, the sample scripts used measurement strings, strings that force InDesign to use a specific
measurement unit (for example, “8.5i” for 8.5 inches). They do this because you might be using a different
measurement system when you run the script.
To specify the measurement system used in a script, use the document’s
viewPreferences object, as
shown in the following script fragment (from the ViewPreferences tutorial script):
var myDocument = app.activeDocument;
with(myDocument.viewPreferences){
//Measurement unit choices are:
//* MeasurementUnits.agates
//* MeasurementUnits.picas
//* MeasurementUnits.points
//* MeasurementUnits.inches
//* MeasurementUnits.inchesDecimal
//* MeasurementUnits.millimeters
//* MeasurementUnits.centimeters
//* MeasurementUnits.ciceros
//Set horizontal and vertical measurement units to points.
horizontalMeasurementUnits = MeasurementUnits.points;
verticalMeasurementUnits = MeasurementUnits.points;
}
If you are writing a script that needs to use a specific measurement system, you can change the
measurement units at the beginning of the script, then restore the original measurement units at the end
of the script. This is shown in the following script fragment (from the ResetMeasurementUnits tutorial
script):
To Next Page
Loading...