IRF2000 series - standard Doc v2.7 13
© ads-tec Industrial IT GmbH • Heinrich-Hertz-Str. 1 • 72622 Nürtingen • Germany
3.2 Operating location
This device is designed for industrial use. Make certain that the specified environmental conditions are
maintained at all times. Use in non-specified environments, i.e., on board ships, in explosive
atmospheres or at extreme elevations, is prohibited.
Risk of short circuit!
To prevent the formation of water condensate, the device may be turned on only after
it has reached the specified ambient temperature. This also applies if the device is
exposed to extreme temperature fluctuations.
Avoid overheating in operation!
The device must not be exposed to direct radiation by sunlight or any other light or
heat source.
Pollution degree acc. to IEC 61010-1 and CSA 22.2 No 107.1-01: pollution degree 2.
This device is designed for use in a controlled environment.
3.3 Damage due to improper use
Should the control system have evident signs of damages caused, e.g., by improper operation or
storage conditions or due to improper use or handling, the device must be shut down immediately.
Ensure that it is secured against being started up accidentally.
3.4 Warranty / repairs
During the device warranty period, any repairs must only be performed by the manufacturer or by
service personnel that has been authorised by the manufacturer.
3.5 Intended use
The Industrial Firewall was specifically designed for the IT security of plant and machinery and the
secure remote maintenance via Internet.
The following applications are realized by the Industrial Firewall:
Remote maintenance, NAT routers, wireless routers, firewall machines, Gigabit Router.
Application-specific applications are buildable on various software development kits (SDK).
The unit must only be installed and operated within the allowed specifications.
The use of an unspecified environment is prohibited.
To Next Page
Loading...
Need help?
General
