Connecting the PCS Instrument
Connect power and USB cables to the rear of the instrument and the
other end of the USB cable to the computer (Do not connect the PCS
through a USB hub, it must be connected directly to the computer).
Ensure the power cable locks into place.
On first connection to the computer, Microsoft Windows will begin installing
drivers for the integrated barcode scanner and the PCS instrument. This
process may take a few moments.
3
PCS Power Switch
See Connecting Accessory Hardware in the ArtelWare Quick Start Guide for
more information about connection with a USB-serial adapter.
Connect power and serial cables to the rear of the instrument.
PCS Instrument PCS2/PCS3 Instrument
To Next Page
Loading...