The Advanced
®
Osmometer Model 3320 Service Manual
SETUP ROUTINES CODE: 6
DATA DESCRIPTION
0 FEATURE LOCKOUT
1 SET BIN NUMBERS
2 SET KEY BEEP
3 SET TIME
4 SET SERIAL RATE
5 SET SERIAL NUMBER
6 SET LANGUAGE
UTILITY ROUTINES CODE: 8
DATA DESCRIPTION
0 RECALL RESULTS
1 STATISTICS
2 EVENT RECORD
3 ASSISTANCE
SETTING CHANGE CODE: 7
DATA DESCRIPTION
NOTE: No subcategories.
EVENT_TEST CODE: 9
DATA DESCRIPTION
NOTE: Data is the final result of a success-
ful test.
CALIB ROUTINE CODE: 10
DATA DESCRIPTION
NOTE: No subcategories.
ERRORS CODE: 5
DATA DESCRIPTION
LEVEL 1 ERRORS
0 System Error: NMI
1 System Error: Trap
2 System Error: ESC
3 Memory Allocation Error
LEVEL 2 ERRORS
100 Fan Driver Failure
101 TE Driver Failure
102 Solenoid Driver Failure
103 Block Probe Open?
104 Block Probe Failure
105 Sample Probe Open?
106 Sample Probe Failure
107 Cooling System Error
108 Event Record Lost
LEVEL 3 ERRORS
200 Sample Pre-Freeze
201 Sample Freeze Error
202 Sample Did Not Freeze
203 No Plateau
204 Test Cancelled
205 Calibration Cancelled
206 Test Time-Out Error
207 Recalibration Needed
208 Standards Reversed?
209 Calibration Out of Range
210 Reset Probe Config.
211 Parameter RAM Failed
212 No Parameters in RAM
213 Count Error: Parameter
214 ROM Serial Number Error
215 Baudrate Error
216 Key Input Timeout
217 Lift Sample Probe
218 A/D Init Failure
219 A/D High Filter Error
ERRORS (continued) CODE: 5
DATA DESCRIPTION
220 A/D Low Filter Error
221 A/D Cal Mode Error
222 Bar Code Cancelled
223 Diagnostics Cancelled
224 Low Battery
225 Out of Range
To Next Page
Loading...
Need help?
General