ADVANSEA multi s400 - 1. Introduction; 1.1. General presentation; 1.2. Components supplied with your MultiS400; 1.3. Technical characteristics

Installation and Operation Manual S400 series 3
1. Introduction
1.1. General presentation ..................................................... p.4
1.2. Components supplied with your MultiS400 ...................... p.5
1.3. Technical characteristics ................................................ p.5
2. General operation
2.1. Powering on.................................................................. p.7
2.2. Operation in normal mode ............................................. p.7
2.2.1. Selecting information on the upper display
2.2.2. Selecting information on the lower display
2.2.3. Selecting units of measurement
2.2.4. Resetting data
2.2.5. Countdown timer
2.2.6. Backlighting
2.3. Alarms .......................................................................... p.10
2.3.1. Setting the echo sounder alarm thresholds
2.3.2. Setting the speed alarm thresholds
2.3.3. Setting the battery alarm threshold
2.4. Configuration ................................................................ p.12
2.4.1. Keel offset
2.4.2. Speed damping
2.4.3. Calibrating the water temperature
2.4.4. Calibrating by speed
2.4.5. Calibrating by log
2.4.6. Configuring the countdown timer
2.4.7. Simulation mode
2.4.8. Key beeps
2.4.9. Resetting data in the memory
2.5. Standby ........................................................................ p.15
2.6. Network operation (Bus AS-1) ........................................ p.16
2.7.1. Displaying multiple data
2.7.2. Remote access
2.7. Messages ...................................................................... p.17
Table of contents