Chapter 4
Chapter 4 Command Set
4-55
4.6.16
$ AA9n(lw)(hw)(ld)(hd)
Name Set pulse output input width
Syntax $AA9n(lw)(hw)(ld)(hd)(cr)
$ is a delimiter character.
AA (range 00-FF) represents the 2-character hexadecimal
address which is to be accessed.
9 is the DI filter input command
n is the channel n
(lw): 8-hexadicimal chrs Low Width=>0x0~0xffffffff
(hw): 8-hexadicimal chrs High Width=>0x0~0xffffffff
(ld): 8-hexadicimal chrs Low Delay=>0x0~0xffffffff
(hd): 8-hexadicimal chrs High Delay=>0x0~0xffffffff
Unit: 0.1ms
(cr) is the terminating character, carriage return (0Dh).
Response !AA(cr) if the command was valid.
?AA(cr) if an invalid command has been issued.
There is no response if the module detects a syntax or
communication error, or even if the specified address does
not exist.
! is a delimiter character indicating that a valid command was
received.
? is a delimiter character indicating that the command was
invalid.
AA (range 00-FF) represents the responding 2-character
hexadecimal address of the digital I/O module.
To Next Page
Loading...