VISLINK
Newswift 90-180 Motorised Antenna
CONTENTS
AMENDMENT RECORD SHEET 1
EMC DECLARATION 2
WARNINGS AND HAZARDS 3
ADDITIONAL SAFETY INFORMATION 4
STOWAGE WARNING 4
1. ANTENNA 5
1.1 INTRODUCTION 5
2. SPECIFICATION 6
2.1 RF 6
2.2 DRIVE CONTROL UNIT 7
2.3 MECHANICAL 7
2.4 ENVIRONMENTAL SPECIFICATION 8
3. INSTALLATION 9
3.1 ANTENNA AND MOUNT 9
3.2 ANTENNA PREPARATION 10
3.3 FITTING THE ANTENNA ON THE MOUNT 11
3.4 FUNCTIONAL DESCRIPTION 13
3.5 OPERATING PROCEDURE 13
3.6 MANUAL OPERATION 13
3.7 GENERAL 13
3.8 MULTIBAND FEEDARM FITTING AND REMOVAL INSTRUCTIONS 13
4. DRIVE CONTROL UNIT 14
4.1 INTRODUCTION 14
4.2 SPECIFICATION 14
4.3 FRONT AND REAR PANEL 15
4.4 REAR PANEL 16
4.5 DCU4000 LEAD CONNECTIONS 16
4.6 INTERNAL LAYOUT 17
4.7 DCU INTERNAL ACCESS 17
4.8 CABLE CONNECTIONS 17
4.9 SURFACE MOUNT REPLACEABLE FUSES 17
4.10 FUNCTIONAL DESCRIPTION 18
4.11 AXIS DRIVE DESCRIPTION 19
4.12 AXIS POSITION MONITORING 19
4.13 AXIS POSITION CALIBRATION 19
4.14 AXIS POSITION AND STOWING CHECKS 20
4.15 SAFETY MICRO-SWITCH OPERATION AND FUNCTION 20
4.16 MANUAL BRAKE OVERRIDE OPERATION AND FUNCTION 20
4.17 ALARMS 21
4.18 F1: DCU POWER SUPPLY VOLTAGE LOW 21
4.19 F2: DCU MOTOR SUPPLY FAILURE 22
4.20 F3: MOTOR DRIVE MODULE INHIBIT 22
4.21 F4: INCLINOMETER FAILURE 22
4.22 F5: INCLINOMETER SUSPECT 22
4.23 F6: DRIVE STALL DETECTED 22
4.24 F7: DRIVE FREEWHEEL DETECTED 22
4.25 F8: DRIVE END OF TRAVEL DETECTED 23
4.26 F9: TX POLARISATION SWITCH FAILURE (OPTIONAL) 23
4.27 F10: AZIMUTH STOW SENSOR FAILURE 23
4.28 F11: ELEVATION STOW SENSOR FAILURE 23
To Next Page
Loading...
Need help?
General