Switch-mode power supply AC2000 N1 / DC2000 N1 / AC3000 N1 / DC3000 N1 - Operating instructions
80001533 EFE en Page 7 of 41
Duties of the specialist personnel
Observe the following safety instructions.
When working in and on electrical installations, fixed rules apply to
prevent electrical accidents. These rules are summarized in the five
safety rules. Observe the five safety rules:
5 Safety rules
1. Disconnect.
2. Secure against reconnection.
3. Check that all poles are de-energized.
4. Earth, close earth switch, short-circuit.
5. Cover or cordon off neighbouring live parts.
After completing the work, cancel the five safety rules in reverse order.
Read the operating instructions. Memorize the safety regulations.
Observe the regulations:
BGV A1 (principles of prevention),
BGV A3 (Electrical installations and equipment),
BGV A8 (safety and health protection labelling at the workplace).
Report any damage to the system and the electrical equipment to the
operator.
Only use spare parts approved by the manufacturer for maintenance
and repair work.
Use the personal protective equipment (PPE) as intended.
Check that the PPE is in good condition and report any defects to the
operator.
If you have long hair, wear a hairnet and no loose clothing or jewellery.
Refit the protective devices after all work on the
system.
To Next Page