16
PD201806 AEG GRID-TIED SINGLE-PHASE SOLAR INVERTER V.1-18 EN
16
Item Quantity
AS-IR01-4000 / AS-IR01-4600 /
AS-IR01-5000 / AS-IR01-3000-2 /
AS-IR01-4000-2 / AS-IR01-4600-2 / AS-
IR01-5000-2: 4 units
DC connector
AS-IR01-750 / AS-IR01-1000 /
AS-IR01-1500 / AS-IR01-2000: 1 pair
AS-IR01-3000: 3 units
AS-IR01-4000 / AS-IR01-4600 /
AS-IR01-5000 / AS-IR01-3000-2 /
AS-IR01-4000-2 / AS-IR01-4600-2 / AS-
IR01-5000-2: 2 pairs
Table 6 Packing list of AS-IR01 and AS-IR01-2 series
3.2 Before installation
3.2.1 Installation tools
Detailed list of the tools required for installation:
No. Installation tool Instruction
1 Marking pen Mark the installation hole
2 Electrodrill Drill in the bracket or wall
3 Hammer Hammer on the expansion bolts
4 Monkey wrench Fix the installation bracket
5 Allen driver Fasten the screws, remove and install AC wiring box
6 Straight screwdriver For AC wiring
7 Megger Measuring insulation performance and impedance
8 Multimeter Check the circuit and AC and DC voltage
9 Electric iron Weld communications cable
Table 7: Required installation tools
3.2.2 Installation place
Select the installation place based on the following considerations:
1. Height from ground level should be enough to ensure that display and status LEDs are easy to read.+
2. Select a well ventilated place sheltered from direct sun radiation and rain.
3. Allow sufficient space around the inverter to enable easy installation and removal from the mounting
surface. Please refer to Figure 8.
4. The environment temperature should range between -25°C~60°C.
To Next Page
