AEG BE7900061M - FOR YOUR SAFETY; Gas Safety Procedures; Gas Pressure Regulator Requirements; Installer and User Responsibilities

5
FOR YOUR SAFETY
If you smell gas
• Turnoffgassupplyatsource.
• Extinguishallnakedflames.
• Donotoperateanyelectricalappliances.
• Ventilatethearea.
• Checkforleaksasdetailedinthismanual.
If odour persists, contact your dealer or gas supplier
immediately.
Do not tamper with the appliance.
Burn-back (fire in burner tube
or chamber)
In the event of a burn-back, where the flame burns
back to the jet, immediately turn off the gas supply
at the control valve on the panel. After ensuring the
flame is extinguished, wait for 1 minute and re-light the
appliance in the normal manner. Should the appliance
again burn back, close the control valve and call a
service technician. Do not use the appliance again until
the service technician has declared that it is safe to
do so.
Gas-pressure regulator
This appliance requires an operating pressure of 2.8
kPa at the appliance. A suitable LPG regulator that
complies with the requirements of SANS 1237 must
be installed.
Important information for the user
This appliance may only be installed by a registered
LP Gas installer. All registered installers are issued
with a card carrying their registration number. Ask to
be shown the card before allowing the installation
work to commence and make a note of the Installer
QCC number. Upon completion of the installation, the
installer is required to explain the operational details of
the appliance together with the safety instructions. You
will be asked to sign acceptance of the installation and
be provided with a completion certificate. You should
only sign for acceptance of the installation when the
installation is completed to your satisfaction.
Note that your invoice is required in the event that you
wish to make a guarantee claim.
Important information for the installer
This appliance may only be installed by a LP gas
installer registered with the Liquefied Petroleum Gas
Association of Southern Africa. The appliance must be
installed in accordance with the requirements of SANS
10087-1 and any fire department regulations and / or
local bylaws applicable to the area. If in doubt check
with the relevant authority before undertaking the
installation. Upon completion of the installation you are
required to fully explain and demonstrate to the user
the operational details and safety practices applicable
to the appliance and the installation.