3. It will be solid yellowduring inclusion, and flash white/green3 timesif paired successfully. If it fails, it will
flash
w
hi
t
e
/red instead.
Advanced Functions.
Z-Wave Resetting MultiSensor 7.
Your MultiSensor can be removed from your Z-Wave network at any time. You'll need to use your Z-Wave network's
main controller to do this and the following instructions tell you how to do this. If you are using other products as your
main Z-Wave controller, please refer to the part of their respective manuals that tells you how remove devices from
your network.
Using an existing gateway:
You may need to refer to your gateway's method of including devices if you do not know how to pair a Z-Wave
device. You may use any gateway to perform an unpair/removal on MultiSensor 7 even if they are not paired
together to factory reset MultiSensor 7.
1.
S
e
t
your
Z
-
W
a
v
e
ga
t
e
w
a
y
i
nto
Z
-
W
a
v
e
unp
ai
r
(
e
x
cl
us
i
on
)
mo
de
.
2.Tap the action button once; the purpleled will light up.
3. If removed successful, the blueled will fade in and out to indicate it is ready to be paired to a new hub.
Manual Hard Resetting MultiSensor 7.
This method is not fully advised unless your gateway has failed, if paired to your network, performing these steps will
factory reset your MultiSensor 7, but may leave a hard to remove phantom/ghost device in your working Z-Wave
network.
1. Make sure the device has been powered.
2. Press and hold the button for 20 seconds. When the red led flash, the device will enter factory reset mode.
To Next Page
Loading...
Need help?
General
