MC2: 10/03/12 Page 29 of 90
AERCO International, Inc. • 100 Oritani Dr. • Blauvelt, NY 10913 • Ph: 800-526-0288
CHAPTER 6: ELECTRICAL
See Electrical Guide GF-115-E for in-depth electrical information.
6.1 Electrical Connections
A complete electrical wiring diagram for the Modulex is provided under separate cover in the manual
package. For electrical ratings, refer to the technical data in Sub-section 2.5. The boiler installation
requires a 120 VAC, 60 Hz – single-phase power input. The electrical connections must conform to
local and NEC or CEC requirements. Utilization of adapters, multiple sockets or extensions cords are
not permitted. It is imperative that these safety requirements be adhered to. If in doubt, request an
accurate assessment of your electric system by highly qualified personnel.
IMPORTANT!
AERCO is not liable for any damage caused by connection to an
improper grounding system. The gas and water feeding pipes and the
central heating system pipes cannot be used as grounding means.
Boiler electric safety is guaranteed only when it is properly connected
to an effective grounding system, which is in compliance with the
regulations in force.
The use of any electrically powered equipment implies the observance of some fundamental rules, such
as:
• Do not touch the boiler with any wet part of your body and/or barefooted; do not pull the supply
cable.
• Do not expose the boiler to sunlight, rain, etc.
• Keep untrained people away from the boiler.
The boiler’s electrical supplying cable must not be replaced by the user.
In case of any damage to the cable, stop the boiler and contact qualified
personnel for its replacement.
IMPORTANT!
Prior to connecting external AC power to the Modulex boiler, the CSD-1
Supply Manifold must be installed using the procedures described in
Piping Guide GF-115-P-H.
To Next Page
Loading...
Need help?
General