Aeritech NB ONE+ - 2.) Manual Mode; 3.) Fenced Mode (GPS)

P
h
i
l did it!
2.) Manual Mode
The FlightController will not interfere with the signals from the RemoteControl / YOUR INPUTS
You have full control over the aircraft.
From NB ONE Reviews
Not too many details here, use this mode to trim the plane in the first flight; once trimmed, land
the plane and "teach" the gyro the new zero position of the sticks; in order to do that you will
need to move the "MODE" switch for 6 times quickly going through all three positions.
The FlightController will "acknowledge" the new settings by waving the ailerons twice.
3.) Fenced Mode (GPS)
In this mode the aircraft will fly within the selected radius, which is here called the fence, and be
fully stabilized.
If the border of this range is reached the aircraft will automatically return to its starting point and
start circling unless you move your control sticks, which will stop the return.
A) Understanding of electronic fence mode
On the FlightController you can set the radius of 100-300 meters of electronic fence
with the Poti “R”
With the GPS module installed and connected the fence mode is activated once the GPS
has logged on – RED LED is ON constantly.
When the aircraft reaches the set fence boundary, it will take the initiative to return.
It should be noted here that when starting the fence mode, the aircraft will not return
immediately, but must fly to the set distance to start the return automatically.
B) During the return flight, the throttle will be controlled by FlightController.
When the aircraft arrives at the take-off point, it will circle over the take-off point.
At this time, pulling the aileron or elevator will release the return circle. Therefore, during
the return flight, please do not pull the remote stick. Only when the aircraft reaches the
set point, should the aileron or elevator stick be moved.
C) With regard to one-click return flight, such as using Manual or Stabilized mode, flying
out of the fence radius, then switching the Fence Mode ON, the aircraft will return
immediately.
Outside the fence, all control of the aircraft is controlled by the FlightController.
When the aircraft enters the fence, the aileron or elevator can cancel the return flight.
Keep in mind that the Fence Mode is not a key return to home, but lets the aircraft fly within the
set radius.
Only when the aircraft reaches the set radius position, it will start the automatic return flight.
Please do not move any RemoteController stick during the return flight.
18 of 21