P
h
i
l did it!
(7) Servo Direction Setting – RemoteController
This is to check for the correct operation of the servos when in (2) Manual Mode
NOTE: Adjustment of servo direction has to be done in the RemoteController!
NOTE: Remove the Propeller for this test and make sure the throttle stick is in the
bottom position.
1. Switch Flight Mode Switch to (2) Manual Mode
2. Move the directional control sticks on the RemoteController in each end position and
check that the servos move in the correct direction.
Correct it on the RemoteController if the direction is wrong
3. The control boards can be manually and mechanically corrected so that their initial
positions are correct.
???
15 of 21
To Next Page
Loading...