Aeritech NB ONE+ - (2) Servo connections

P
h
i
l did it!
(2) Servo connections
Connect the servos to the respective OUT Ports of the FlightController
For the Aileron Out you need a Y-Cable to connect 2 Servos for separate aileron controls.
Connect the GPS Antenna to the respective port on the FlightController.
OUT to Servos
Aileron
Elevator
Throttle
Rudder
GPS
S + -
IN from Receiver
Aileron
Elevator
Throttle
Rudder
Mode Select
”THR_OUT_3” channel is connected to the ESC for all models.
Aileron servo 1 I
Aileron servo 2 I T-tail
Elevator servo I V-Tail
Rudder servo I
Aileron servo 1 I
Aileron servo 2 I Delta wing
Rudder servo I
From NB ONE Manual
8 of 21