Aermec cod. INRLLSIY 13_01. 4086991_00
NRL 800 - 1800
GB
User Interface (PGD1)
The unit control panel allow the quick se ng and
display of the unit’s opera ng parameters. The board
memorises all the default se ngs and any modifi ca-
ons. By installing the remote control panel PGD1 it is
possible to remotely replicate all the func ons and the
se ngs available on the unit. A er a power failure the
unit is capable of an automa c restart, retaining the
original se ngs.
The user interface consists of a graphic display with
six naviga on keys; the display is arranged through a
menu hierarchy, ac vated by pressing the naviga on
keys. The default display of these menus is the main
screen. The naviga on between the various parame-
ters is by using the arrow keys located to the right of
the display. These keys are also used for the modifi ca-
on of the selected parameter.
Key Fucntion
ALARM key
Displays the list of active and historical alarms
(red LED on = active alarm)
MENU ACTIVATION key
• Pressing this key activates the navigation between menus
(orange LED on = winter operating mode active)
EXIT MENU key
• Pressing this key returns to the previous menu
NAVIGATION (+) key
• Pressing this key when modifying a parameter increases the value of the selected parameter
NAVIGATION (enter) key
• Pressing this key when navigating between menus allows entry to the selected menu
• Pressing this key when navigating between parameters allows selection of the parameter
displayed to modify it
• Pressing the key when modifying a parameter confirms the modification of the parameter value
selected
NAVIGATION (-) key
parameter
• Pressing this key when modifying a parameter decreases the value of the selected parameter
Control Keys
INTERFACE CONTROL KEYS
Control Keys
Start-up procedure
A er having powered up the unit the control board will
carry out preliminary opera ons before being ready
for use. This ini al procedure takes around 60 seconds
to complete. During the ini al loading procedure two
screens are displayed: a start-up screen and a screen to
select the system language. These screens are detailed
in the table below.
WARNING: The system language can be set on the
in the Installer menu.
Display on the unit Index Display/Parameter
C
B
Wait please 6s
A
Installer
ENTER for change
Language:
Time show mask:
English
ESC to confirm
20
A
Remaining time for software loading: this value shows the remain-
ing time to starting the software loaded on the unit, and passing the
to system language selection
B
System language: this parameter shows the current language set for
the system. To change the language follow the instructions shown on
the screen.
C
Remaining time to select the language: this value shows the
remaining time to modify the language. When the time elapses the
display goes to the main screen (Main screen - General monitoring).
WARNING: It is possible to modify the system language at any
time using the appropriate screen contained in the Installer menu.
(Menu password = 0000).
WARNING: It is possible to modify the system language at any time using the appropriate screen contained in the Installer menu. (Menu password = 0000).
14. START-UP PROCEDURE
To Next Page
Loading...
