4
Aermec cod. INRLLSIY 13_01. 4086991_00
NRL 800 - 1800
GB
1. DESCRIPTION AND CHOCE OF UNIT
2. COMPONENTS AND CONFIGURATIONS
COMPONENTS VERSIONS
COOLING CIRCUIT ° H C D T
yes yes no no no
yes yes no yes yes
no no no no yes
no no no yes no
AIR SIDE EXCHANGE yes yes yes yes yes
COMPRESSOR yes yes yes yes yes
DEHYDRATOR FILTER yes yes yes yes yes
HIGH PRESSURE SWITCH yes yes yes yes yes
HIGH PRESSURE TRANSDUCER yes yes yes yes yes
LOW PRESSURE TRANSDUCER yes yes yes yes yes
LIQUID INDICATOR yes yes yes yes yes
LIQUID TANK no yes no no yes
no yes no no yes
LIQUID SEPARATOR no yes no no yes
CYCLE REVERSE VALVE no yes no no yes
Chillers and heat pumps for outdoor condensed
in the air with R410A Series NRL have been de-
signed and manufactured to satisfy heating and
cooling needs and the production of domestic
hot water (DHW) in medium to small commercial
or residential buildings.
Maximum reliability
The presence of several scroll compressors allows
NRL chillers various partialisations of the cooling
capacity.
Models:
1. NRL "°" standard chiller
2. NRL "H" heat pump *
3. NRL "C" motocondensing
The versions can be in different set-ups at the
same time in order to satisfy a wide range of
plant engineering solutions:
1. "A" HIGH EFFICIENCY
2. "E" SILENCED HIGH EFFICIENCY
3. "D" WITH DESUPERHEATER
4. "T" WITH TOTAL RECOVERY
Configurations not allowed:
* Possibility of production of D.H.W.
(DCPX_UL | VMF-ACS | AER485).
Standards and Directives
respected on designing and
constructing the unit:
PROTECTION RATING
1. IP 24
ACOUSTIC PART:
1. ISO DIS 9614/2
(INTENSIMETRIC METHOD))
2. SOUND POWER (EN ISO
9614-2)
3. SOUND PRESSURE (EN ISO
3744)
REFRIGERANT GAS:
This unit contains fluoride
gases with greenhouse effect
covered by the Kyoto Proto-
col. Maintenance and dispo-
sal must only be performed by
qualified staff.
STANDARD:
UL 1995
Heating and cooling equip-
ment.
ANSI/NFPA
Standard 70 National Electri-
cal code (N.E.C.).
CSA C.22.1.- C.22.2
Safety Standard Electrical
Installation.
To Next Page
Loading...
