Subject to Export Control, see Cover Page for details. 2-3
2-2-3. TROUBLESHOOTING PRECAUTIONS
WARNING
• REMOVE ALL JEWELRY OR OTHER COSMETIC APPAREL BEFORE
PERFORMING ANY TROUBLESHOOTING INVOLVING LIVE CIRCUITS.
• WHEN WORKING WITH LIVE CIRCUITS OF HIGH POTENTIAL, KEEP ONE
HEN WORKING WITH LIVE CIRCUITS OF HIGH POTENTIAL, KEEP ONE
HAND IN POCKET OR BEHIND BACK TO AVOID SERIOUS SHOCK
HAZARD.
• USE ONLY INSULATED TROUBLESHOOTING TOOLS WHEN WORKING
WITH LIVE CIRCUITS.
• FOR ADDED INSULATION, PLACE RUBBER BENCH MAT UNDERNEATH
ALL POWERED BENCH EQUIPMENT, AS WELL AS A RUBBER MAT
UNDERNEATH TECHNICIAN'S CHAIR.
• HEED ALL WARNINGS AND CAUTIONS CONCERNING MAXIMUM
VOLTAGES AND POWER INPUTS.
CAUTION
THIS EQUIPMENT CONTAINS PARTS
SENSITIVE TO DAMAGE
BY ELECTROSTATIC DISCHARGE (ESD)
CAUTION
ALL ASSEMBLIES CONTAIN PARTS SENSITIVE TO DAMAGE BY
ELECTROSTATIC DISCHARGE (ESD). ALL PERSONNEL PERFORMING
TROUBLESHOOTING PROCEDURES SHOULD HAVE KNOWLEDGE OF
ACCEPTED ESD PRACTICES AND/OR BE ESD CERTIFIED.
2-2-4. EMC / SAFETY COMPLIANCE
All assemblies, cables, connectors, plastic fasteners, gaskets, fingerstock and miscellaneous
hardware within the Test Set are configured to satisfy the safety and EMC compliance standards.
CAUTION
UPON COMPLETION OF ANY MAINTENANCE ACTION; ALL ASSEMBLIES,
CABLES, CONNECTORS, PLASTIC FASTENERS, GASKETS, FINGERSTOCK
AND MISCELLANEOUS HARDWARE MUST BE CONFIGURED AS INSTALLED
AT THE FACTORY.
To Next Page
Loading...
