Aesthetix MIMAS - Headphone and Balance; Volume and IR Settings

13
Headphones
By default the Headphone feature is set to OFF. The Mimas will auto sense when headphones are plugged in
and the display will indicate that the Headphone (HP) jack is enabled (ON). This will disable the speaker outputs.
When the headphones are unplugged, the Mimas will disable the Headphone jack and enable the speaker
outputs. Caution is to be given to note the Master Volume level prior to unplugging headphones.
The Headphone jack setting can be changed while headphones are plugged in. This is useful when the user
wishes to leave the headphones connected and go back and forth between listening to the speakers or the
headphones.
To enable or disable the Headphone jack, first press the SETUP button. If the menu does not say GEN,
repeatedly press the right side of the display until it does. Press the INPUT button. The display will read OFF HP
or ON HP. Toggle this parameter by pressing the left/right side of the display or the UP/DOWN buttons on the
remote. Press the SETUP button to exit, or the INPUT button to access additional programmable features.
Caution!! It is important to note that any time the headphones are unplugged from the front panel,
the speakers will automatically be enabled. Please note the Master Volume level prior to
disconnecting the headphones.
Balance
The Balance can be shifted 12dB to the left or right. Going past that turns the opposite speaker off.
To access this menu, press the SETUP button. If the menu does not show GEN, repeatedly press the right side
of the display until it does. Press the INPUT button two times to display BAL 00. Press the volume UP or DOWN
button on the remote, or the right/left side of the front panel lens to set the desired Balance. Press the SETUP
button to return to the Main menu.
Start Level
The factory default is 0 and the programmable range is 0-20.
To set the volume level that the Mimas will be at when coming out of Standby, press the SETUP button. If the
menu does not show GEN, repeatedly press the right side of the display until it does. Press the INPUT button
three times to display STL XX. Press the volume UP button on the remote or the right side of the front panel lens
to set the desired level. Press the SETUP button to return to the Main menu.
Maximum Level
The factory default is 88 and the programmable range is 50-88.
To set the maximum volume level that the Mimas will go to, press the SETUP button. If the menu does not show
GEN, repeatedly press the right side of the display until it does. Press the INPUT button four times to display
MAX: XX. Press the volume down button on the remote or the left side of the front panel lens to set the desired
level. Press the SETUP button to return to the Main menu.
IR (Infrared)
The factory default is Mima[s].
To set whether the Mimas responds to a Mimas or Calypso remote, press the SETUP button. If the menu does
not show GEN, repeatedly press the right side of the display until it does. Press the INPUT button five times to
display MIMA IR. Press the volume UP or DOWN button on the remote or either side of the front panel lens to
select the desired response. Press the SETUP button to return to the Main menu.