Aesthetix MIMAS - Input Configuration; Input Management; Input Naming and Bypass

15
Setup Input
The individual Input Setup options are:
o Enable/Disable the currently selected Input.
o Adjusting the input level to match that of other inputs.
o Selecting an Input(s) to be used for Home Theater Bypass.
o Naming an enabled Input.
o Selecting advanced Home Theater Bypass options.
At any time that a sub menu is displayed, pressing the Input button will advance to the next parameter. Pressing
the left and/or right side of the front panel lens (UP/DOWN buttons on the remote) will edit the displayed
parameter value. When Naming an Input or setting advanced Home Theater bypass options, the DISPLAY
button is used to enter these sub menus first. In these cases, the Display LED will be illuminated. In all sub
menus except NAME, the Mute feature is active.
The factory settings for each Line Input Name are Inp1, 2, 3, 4 or 5 and TT 1, TT 2 for the two Phono Inputs.
The instructions in this section will edit Inp1.
Note: When editing Input specific parameters, the name of the Line input to be edited will be SET1, 2, 3, 4 or 5.
The Phono Inputs will be P1 and P2.
* * *
Input On/Off
The factory default setting for each Input is ON.
From the Main menu, to set whether an Input is active or not, press the SETUP button. Press the left or right
side of the Display (UP/DOWN buttons on the remote) to select SETx, where x = the input to be edited. In this
example, SET1. Press the INPUT button once. Press the left or right side of the Display (UP/DOWN buttons on
the remote) to turn the Input On or Off. Press the SETUP button to exit and return to the Main menu.
Input Level
The factory default is 0.
Line level sources may have different output levels. To streamline this, the Mimas allows the user to adjust any
Input level to match that of other sources. The range is –12 to + 12.
To change the offset of Input 1, from the Main menu press the SETUP button. Press the left or right side of the
Display to select SET1. Press the INPUT button twice so that the display reads LVL. Use the left or right side of
the Display (UP/DOWN buttons on the remote) to select the desired value. If the source is playing, the user will
hear the audio level change as the displayed value does. Press the SETUP button to exit and return to the Main
menu.
Home Theater Bypass
The factory default is OFF. On the Main menu, a Bypassed input will be displayed as INPx BP, and volume &
mute changes are disabled, as the source device will control these features.
From the Main menu, to enable or disable Bypass for Input1, press the SETUP button. Press the left or right side
of the Display to select SET1. Press the INPUT button three times so that the display reads NORM or BYP. Use
the left or right side of the Display (UP/DOWN buttons on the remote) to select the desired value. Press the
SETUP button to exit and return to the Main menu. Refer to Bypass (Advanced) on the next page for additional
bypass options.