Need help?Do you have a question about the Aeware in.xm and is the answer not in the manual?
General| Brand | Aeware |
|---|---|
| Model | in.xm |
| Category | Control Systems |
| Language | English |
Step-by-step instructions for floor installation, including material recommendations and safety warnings.
Detailed instructions for wall mounting the spa pack, including necessary materials and mounting tips.
Details the procedure to set the learning mode for system verification of output current consumption.
Introduces the troubleshooting section, highlighting in.scan™ for error detection and diagnosis on connected devices.
Lists and explains SP error codes (SP-HR, SP-BR, SP-IN, SP-F1) for spa pack malfunctions.
Details further SP error codes (SP-F2, SP-F3, SP-OT, SP-OH) related to blown fuses and overheat conditions.
Provides corrective actions for SP-HR (hardware error) and SP-BR (current configuration) errors.
Details corrective actions for SP-IN (voltage issue) and SP-F1 (blown fuse) errors.
Outlines corrective actions for SP-F2 and SP-F3 errors, involving fuse replacement and component testing.
Addresses SP-OT (high temp) and SP-OH (overheat) errors with cooling and diagnostic steps.
Lists and explains RH error codes (RH-HR, RH-NH, RH-NF, RH-NC, RH-HL) for the in.therm™ heater.
Explains RH error codes (RH-PR, RH-ID) for regulation probe and model incompatibility issues.
Provides corrective actions for RH-HR (hardware error) and RH-NH (no heat) in the in.therm™.
Lists error codes (P1-ER, P2-ER, P3-ER, P4-ER, P5-ER, CP-ER) for high voltage devices indicating no current change.
Lists error codes (BL-ER, FN-ER, SC-ER) for blower, fan, and system learning issues.
To Next Page