Afikim PRS4024a - Page 17

17/21
10.
Secure HP2 profile upon
center beam.
Push up the assembly plastic
sheet and remove the foam
tape AC00198 adhesive
protection layear.
(come upon the center
beam).
Press the HP2 profile agenst
the center beam firmly and
evenly.
Make sure that the HP2
profile is in good contact.
Note: Foam tape AC00198
will have the max adhesive
strength after 72 hours.
TOP-VIEW
HP2 profile
Center beam
+ foam Tape
In black
Peel off
protection layer
Push down