AGA 60 - Installation introduction; Regulatory compliance and installer checks

19
Consumer protection
As a responsible manufacturer, we take care to make sure
that our products are designed and constructed to meet the
required safety standards when properly installed and used.
CAUTION: THIS INSTALLATION MUST MEET THE
REQUIREMENTS OF AS/NZS 5601, AND MUST CONFORM
WITH LOCAL GAS AUTHORITIES AND SAA ELECTRICAL
WIRING RULES AS 3000 AND ONLY USED IN A WELL
VENTILATED SPACE, READ THESE INSTRUCTIONS BEFORE
INSTALLING OR USING THIS APPLIANCE.
PRIOR TO INSTALLATION, ENSURE THAT THE LOCAL
DISTRIBUTION CONDITIONS (NATURE OF GAS AND GAS
PRESSURE) AND THE ADJUSTMENTS OF THE APPLIANCE
ARE COMPATIBLE.
THE GAS ADJUSTMENT CONDITIONS FOR THIS APPLIANCE
ARE STATED ON THE DATA PLATE WHICH ON A PULL-OUT
PLATE BEHIND THE PLINTH COVER.
Refer to the “Checks for the installer” on page 19 to test
the operation of appliance.
This appliance is not connected to a combustion products
evacuation device. It shall be installed and connected in
accordance with current installation regulations. Particular
attention shall be given to the relevant requirements
regarding ventilation.
It should be in accordance also with any relevant
requirements of the Gas Region and Local Authority.
On completion test the gas installation for soundness and
purge. Leak testing of the appliance shall be conducted
according to the manufacturer’s instructions.
NOTE: Use soapy water solution on new gas connections to
ensure there are no gas leaks.

WARNING - ELECTRIC SHOCK HAZARD
It is the customers responsibility to contact a qualied
electrical installer to make sure the electrical installation is
adequate and in conformance with SAA ELECTRICAL WIRING
RULES AS 3000.
Take special care when cutting holes in walls or oor.
Electrical wires may be behind the wall or oor covering and
could cause an electrical shock if you touch them.
Locate any electrical circuits that could be aected by the
installation of this product and disconnect power circuit.
Electrical earth is required on this appliance.
DO NOT use an extension lead with this appliance.
10. Installation introduction
Checks for the installer
Check with a qualied electrician if you are not sure the
appliance is properly earthed.
Failure to follow these instructions could result in death or
serious injury.
Check the operation of the appliance to ensure the hotplate
burners ignition operates correctly on individual burners and
in combination with other burners. Check ame picture and
ame stability.
Check oven elements heat up and that ovens reach
temperature.

WARNING: THIS APPLIANCE MUST BE EARTHED.
• The appliance is designed for the voltage stated on the
data plate.