27
Service and Spares
Please complete the appliance details below
and keep them safe for future reference - this
information will enable us to accurately identify
your particular appliance and help us to help
you. Filling this in now will save you time and
inconvenience if you later have a problem with
your appliance. It may also be of benet to keep
your purchase receipt with this leaet. You may
be required to produce the receipt to validate a
warranty eld visit.
Fuel Type: Dual Fuel
Name of Appliance & Color*
AGA Legacy 36
Appliance Serial Number *
Retailers Name & Address
Date of Purchase
Installers Name & Address
Date of Installation
* This information is on the appliance data badge.
If you have a problem
In the unlikely event that you have a problem
with your appliance, please refer to the rest of this
booklet, especially the problem solving section,
rst to check that you are using the appliance
correctly.
If you are still having diculty, contact : -
AGA Marvel
1260 E. VanDeinse St.
Greenville, MI 48838
Business (616) 754-5601
Fax: (616) 754-9690
Toll Free Telephone 800-223-3900
Make sure the oven is cool. Open the oven door
and remove the Handyrack (if tted) and oven
racks.
Turn off the power supply.
Unscrew the bulb cover by turning counter
clockwise. Unscrew the old bulb. Screw in the
new bulb, screw back the bulb cover. Turn on the
electricity supply and check that the bulb now
lights.
Cooktop ignition or cooktop burners faulty
Is the power on? Is the clock illuminated? If not
there maybe something wrong with the power
supply.
See ‘power supply’ section further on.
Are the sparker (ignition electrode) or burner slots
blocked by debris?
Is the burner trim correctly located?
Are the burner caps correctly located?
See the section entitled ‘Cleaning’
Remember that each cooktop burner has a special
safety device that stops the ow of gas if the ame
goes out. When lighting a cooktop burner the
safety device has to be overridden by holding the
control knob so that the gas can ow. This allows
the ame sensor to heat up and operate the safety
device. Keep holding the knob pressed in to let
the gas through to the burner for few seconds. The
igniter should spark and light the gas.
If, when you let go of the control knob, the burner
goes out, the safety device has not held in. Turn
the control to the o position and wait one minute,
then try again this time holding in the control knob
for slightly longer.
Cooktop burners will not light
If only one or all the cooktop burners will not
light, make sure that the parts have been replaced
correctly after wiping or removing for cleaning.
Check that there is not a problem with your gas
supply. You can do this by making sure that other
gas appliances you may have are working.
Do the burners spark when you push the button? If
not check the power is on - is the clock illuminated?
To Next Page
Loading...
Need help?
General
