48
Set for Natural gas Set for Propane gas
The snap in converter device is marked to show which
gas it is set for. Make sure the device is secure in the
base of the nut and ret the nut to the regulator.
Type 2
The regulator has a
bayonet mounted top
cap.
Using a small coin
press in and turn the
cap to remove it.
Turn the cap over so that the letters “LP” are visible on
base of the hollow in the cap. Ret the cap, making sure
that the bayonet pins are securely located.
Set for Natural gas Set for Propane gas
Stick on Label
Stick the appropriate label on to the data badge to
indicate the gas the appliance is now set for. The data
badge is located under the Main oven. Remove the
plinth by pulling forward (it is held in place by magnetic
catches) and pull forward on the sheet metal tag under
the center of the oven to swing out the badge plate.
Pressure Testing
The gas pressure can be measured at the pressure test
point on the appliance side of the pressure regulator.
View from above with the ue grille removed
Connect the appliance to the gas supply. Check the
appliance is gas sound.
Refit the Flue grille assembly
Check the appliance is gas sound.
Check operation of all the burners.
To Adjust the Oven Door Angle
The door bottom hinge can be adjusted to alter the
angle of the door.
Loosen the bottom hinge xing screws and use the
notch and a at bladed screwdriver to move the
position of the hinge to set the hinge position.
Retighten the hinge screws.
Eect of hinge adjustment – exaggerated for clarity
Centre line of hinge pin
Oven door omitted for clarity
To Next Page
Loading...
Need help?
General
