46
Shut o the gas supply and disconnect electrical
supply to appliance. Disconnect gas supply tubing
to appliance and unplug the electrical supply cord.
Reverse procedure to reinstall. If gas line has
been disconnected, check for gas leaks after
reconnection.
NOTE: A qualied person should disconnect and
reconnect the gas supply.
The service engineer MUST follow installation
instructions provided with the gas appliance
connector and the warning label attached to the
connector.
If your range is removed for any reason, make sure
the anti-tip device is re-engaged properly when
the range is replaced. Failure to take this precaution
could result in tipping of the range and cause
injury.
How To Remove the Range
for Servicing
Follow these procedures to remove appliance for
servicing:
The range is very heavy. Take great care. We
recommend two people maneuver the range.
Ensure that the oor covering is rmly attached,
or removed to prevent it being disturbed when
moving the range around.
There are two leveling rollers at the back and also
two screw down leveling feet at the front.
Open the broiler door and right hand oven door so
that you can get a good grip on the bottom of the
control panel as you move the oven.
ArtNo.010-0004 Moving the cooker
Do not move the range by pulling the door
handles or knobs.
Lift the front slightly and
slide
the range forward to disengage from the anti-tip
bracket.
Move the range a bit at a time, checking behind it
to make sure the gas hose is not caught. Make sure
both electricity and gas cables have sucient slack
to move the range forward as you go along
Conversion to Another Gas
This appliance is supplied set for Natural gas. A
conversion kit for Propane gas is supplied with the
range.
If the appliance is to be converted this must be done
before installation. The conversion must be performed
by a qualied LP gas installer. After conversion the
installation must comply with the relevant regulations
and also the local electricity supply company
requirements. Read the instructions before converting
this appliance.
Failure to convert the appliance correctly could
invalidate any warranty or liability claims and lead to
prosecution.
This instruction must be used in conjunction with
the rest of the appliance instruction, in particular
for information on Standards, range positioning,
connection hose suitability etc.
When servicing or replacing gas-carrying components
disconnect from gas before commencing operation and
check appliance is gas sound after completion.
Do not use re-conditioned or unauthorised gas controls.
To Next Page
Loading...
Need help?
General
