29
Using your Range
Oven not coming on when automatic cooking
Timer set correctly but oven knob left OFF by
mistake?
Is the key symbol (
) showing in the display?
See the Clock section of the instructions for
more information on the key lock feature of the
clock.
If using the Multi-function oven have you set a
cooking function?
Oven temperature getting hotter as the range
gets older
If turning the knob down has not worked or only
worked for a short time then you may need
a new thermostat. This should be fi tted by a
service person.
Broiler not cooking properly
Are you using the pan and grid supplied with the
range? Is the pan being used on the runners,
not the fl oor of the compartment? Is the broiler
tray pushed fully back to stop?
The oven light is not working
The bulb has probably burnt out. You can buy a
replacement bulb (which is not covered under
the guarantee) from a good electrical shop.
Ask for a 15w 125-130v lamp, FOR OVENS. It
must be a special bulb, heat resistant to 300°C
(570°F).
Make sure the oven is cool. Open the oven door
and remove the Handyrack (if fi tted) and oven
racks.
Turn off the power supply.
Unscrew the bulb cover by turning counter
clockwise. Unscrew the old bulb. Screw in the
new bulb, screw back the bulb cover. Turn on the
electricity supply and check that the bulb now
lights.
Cooktop ignition or cooktop burners faulty
Is the power on? Is the clock illuminated? If not
there maybe something wrong with the power
supply.
See ‘power supply’ section further on.
Are the sparker (ignition electrode) or burner
slots blocked by debris?
Is the burner trim correctly located?
Are the burner caps correctly located?
See the section entitled ‘Cleaning’
Remember that each cooktop burner has a
special safety device that stops the fl ow of gas
if the fl ame goes out. When lighting a cooktop
burner the safety device has to be overridden
by holding the control knob so that the gas can
fl ow. This allows the fl ame sensor to heat up and
operate the safety device. Keep holding the knob
pressed in to let the gas through to the burner
for few seconds. The igniter should spark and
light the gas.
If, when you let go of the control knob, the
burner goes out, the safety device has not held
in. Turn the control to the off position and wait
one minute, then try again this time holding in
the control knob for slightly longer.
Cooktop burners will not light
If only one or all the cooktop burners will not
light, make sure that the parts have been
replaced correctly after wiping or removing for
cleaning.
Check that there is not a problem with your gas
supply. You can do this by making sure that other
gas appliances you may have are working.
Do the burners spark when you push the
button? If not check the power is on - is the clock
illuminated?
To Next Page
Loading...
Need help?
General
