79034308 B Rev. 02-1
General Information
GENERAL INFORMATION
INTRODUCTION
The information contained in this manual covers service
information for the DynaFlex™ Header.
The header operator's manual as well as the machine
operator’s manual must be kept at hand for reference at
all times.
Units of Measurement
Measurements are given in metric units followed by the
equivalent in U.S. units. Hardware sizes are given in
millimeters for metric hardware and inches for U.S.
hardware.
Replacement Parts
To receive efficient service, always give the following
information:
• Correct part description or part number.
• Model number of the machine.
• Serial number of the machine.
Machine Identification
FIG. 1: Each machine is identified by type and serial
number on the serial number plate (1). The serial number
plate on the header is located to the left of the combine
interface.
FIG. 1
To Next Page
Loading...
Need help?
General
