General Information
02-2 79034308 B Rev.
Header/Machine Usage
General
All models are equipped with hydrostatic reel drive.
The header is equipped with a flexible cutterbar and
Automatic Header Height Control (AHHC).
As a Flex Draper, the four or six sensors (potentiometers)
installed on each end and throughout the center of the
header are specifically designed to operate with the
AHHC control module installed in the machine.
As a Rigid Draper, the tilt arms are locked up and drag
rods with sensors are located at each end of the header.
The header is recommended for use in beans, peas,
cereal grains, and low bearing crops and can be used
with the cutterbar locked up or in the float position
depending on the application.
To Next Page
Loading...
Need help?
General
