AGFA CR 35-X - The user interface

30
4454C EN 2013-05-14The user interface
CR 35-X DIGITIZER
The user interface
The CR 35-X has three operation modes:
• the operator mode for basic operation;
• the key-operator mode for advanced operation;
• the service mode reserved for trained service personnel.
The functions of the operator mode are described in Chapter 2, ‘Basic
operation (‘Operator mode’)’. An overview of the functions of the key-operator
mode is given in ‘Survey of advanced functions (‘Key-operator mode’)’ on
page 64. For detailed information on the key-operator mode, refer to the
CR 35-X Reference manual.An overview of the functions of the key-operator
mode is given in ‘Survey of advanced functions (‘Key-operator mode’)’ on
page 64. For detailed information on the key-operator mode, refer to the
CR 35-X Reference manual.
The CR 35-X interfaces with the user via:
• a keypad and a display;
• a status indicator;
• emergency buttons;
• audio signals.
3
12
1
Status indicator
2
Emergency buttons
3
Keypad and display