AGFA CR 35-X - Troubleshooting checklist

65
4454C EN 2013-05-14 Troubleshooting checklist
CR 35-X DIGITIZER
Troubleshooting checklist
A survey of possible problems is listed below. If corrective actions are
straightforward, they are given below. The more elaborate troubleshooting
procedures are explained in detail in Chapter 4, ‘Troubleshooting’ of the CR 35-
X Reference manual.
General errors
Errors during operation
Error Action
The CR 35-X does not start up.
Refer to ‘Checking the voltage supply’ on page 116 of
the Reference manual.
Status field:
Error field:
ERROR
‘SERVICE XXXXX’
Contact your local service organization.
Set-up display STATUS
FUNCTION MODE
1ST MESSAGE ARRAY
2nd Message Array
Patient_Last_Name Sub_Exam
Patient_Last_Name Sub_Exam
Patient_Last_Name Sub_Exam
Station Name ERROR