42
4454C EN 2013-05-14Workflow
CR 35-X DIGITIZER
Workflow
The workflow for identifying cassettes and digitizing image plates depends on
the configuration of your system.
In the interchangeable configuration a cassette is uniquely identified by the
identification data in the cassette chip. Therefore, you must first identify the
cassette via the ID Station with ID Tablet before you can digitize the image
plate. Refer to ‘Reading an image plate in the interchangeable configuration’ on
page 43.
In the dedicated configuration the identification data are transmitted from
the ID Station to the dedicated CR 35-X via the network. Therefore, the CR 35-X
can digitize the image plate while you are entering the identification data on
the ID Station. Refer to ‘Reading an image plate in the dedicated configuration’ on
page 45.
Note: An exception are emergency image plates which you can digitize
without having identified the cassette. The unidentified emergency image
plate will be given default ID data. Refer to ‘Reading an emergency image
plate in the interchangeable configuration’ on page 48.
To Next Page
Loading...
